This was a very demotivating week for me.

I was excited to begin coding my ATTiny412,
but I realized after these multiple hours of work
that my traces were flatout wired wrong.

I had missed that pin 6 in the schematic was not the same as PA6.
This led me to mistake the UPDI pin for the NeoPixel data pin and vice versa.
My traces weren't wide enough to accomodate an ad-hoc change like this.

I had failed and needed to start over.

My other classes held me closely.
I didn't do a lot this week and fell behind.

This is not a project I'm going to finish...