Schematic
I did two different attempts (though the second is unfinished), where I did it purely off of what I thought would work, and then the second after doing light research.
This week was more work with circuit boards
I would call this week a pretty bad failure. I did not have enough time to get around to I2C and none of my boards(the one from last week and week 4) wanted to print correctly with the carvera. I will definetly need to mess around with the drill settings and reach out for help.
I did somewhat finish the schematic, though I will need to look more into motor drivers, motors, and pinout layouts. This week was rough, but I did learn a lot.
I did two different attempts (though the second is unfinished), where I did it purely off of what I thought would work, and then the second after doing light research.
